In a message dated 8/23/98 3:09:52 PM Eastern Daylight Time,
ROBCOULTER@prodigy.net writes:
> One question - upon
> >reading the installation instructions (I learned a long time ago - read
> >them first) it states to torque using "pounds per inch" not "pounds
> >per foot" . My torque wrench only references pounds per foot. My dumb
> >question is can I still use it? Speed Bleeders states to torque them to
> >32-40 pounds per inch. I thinking that it would be roughly 3-5 lbs
> >using my wrench.
Just snug them up like you would any bleeder!
|