I was thinking the same thing... I wouldn't want to be in the bay while
it was sampling :|
-Alan
'99 TG
D. Mallinson wrote:
> I doubt if the difference between 35 psi and 70 would make 5%
> difference, but that is just a guess based on when I had my Dynojet.
> I could see 1-2 hp difference at most, in a 10psi bump, but we never
> recommended much over 5psi over factory recommendation due to the
> chance of the tire exploding.
> Modern radials have pretty low rolling resistance, and more pressure
> doesn't make as much difference as it used to with bias ply tires.
>
> I don't know of any passenger tires that say 50+ is safe. Especially
> at 100+ mph. With the tie-downs forcing the tire down, you can get a
> lot of heat quickly.
>
> Don Mallinson
>
> Paul L Fisher wrote:
>
>> OK. But what are we talking, 10%, 20%?
>>
>>
>> Paul L Fisher
>>
>> Visit my website: http://www.paul-fisher.com
>> Amsoil dealer: http://www.paul-fisher.com/oil
>>
>>
>> -----Original Message-----
>> From: shotimes-admin@autox.team.net
>> [mailto:shotimes-admin@autox.team.net]
>> On Behalf Of Bob
>> Sent: Monday, September 04, 2006 3:44 PM
>> To: shotimes@autox.team.net
>> Subject: RE: [Shotimes] N/A Dyno 318hp 279tq
>>
>> Because it reduces driveline losses through the tires. Unless this is a
>> salt car, 70 psi is twice normal inflation which will cause
>> less rolling resistance via a smaller contact patch and less power
>> will be
>> absorbed by the normally flexing sidewalls. In the real
>> world, 70 psi would leave the vehicle with significantly reduced
>> traction,
>> but in this case, the tie-downs prevent slippage. This
>> throws off the load calculations and creates an unrealistic environment.
>> Most likely, the tuning was done under real world
>> conditions and then the owner told the operator to get some good
>> numbers.
>>
>> If someone wants to use a dyno as a simulator so that tuning can be
>> done,
>> the general goal is to get the dyno variables as close to
>> real world as possible. This would include a real world curb weight
>> with
>> 1/2 tank gas and a driver.
>>
>> -- Bob
>>
>>
>>
>>> -----Original Message-----
>>> From: Paul L Fisher [mailto:sho@paul-fisher.com] Sent: Monday,
>>> September 04, 2006 1:03 PM
>>> To: 'Bob'; shotimes@autox.team.net
>>> Subject: RE: [Shotimes] N/A Dyno 318hp 279tq
>>>
>>> Huh?
>>>
>>> How does that increase your HP?
>>>
>>>
>>> Paul L Fisher
>>>
>>> Visit my website: http://www.paul-fisher.com
>>> Amsoil dealer: http://www.paul-fisher.com/oil
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
|