Can you elucidate on the "90 degree joint"? I'm not sure what you mean.
Also, I'm assuming the piece of aluminum mounts vertically?
--
Mike Wojton
Dover, PA
-'95 White MTX
'96 Brake Upgrade
Eibachs (front)
Dynomax catback
"Avoid the clap." - Jimmy Dugan
On 8/7/06, FlamingTaco <flamingtaco@earthlink.net> wrote:
>
> You can take a length of 2" angle aluminum, put a 90 degree joint in it,
> and mount via the bumper retention bolts. Puts the aluminum right where you
> need it for bottom, rear, or top-mount lamps, depending upon how far down
> you run it. Brace the open corner in the aluminum or the lamps will shake
> noticeably if you're not on stock suspension. Pretty easy to do, no bending
> or angle cuts required. Hacksaw and drill or better required.
>
> Drops 5 Lbs off your SHO, too.
>
> David
>
>
>
> >VO.... this is why you CAN NOT leave the list.
> >BTW... I want to ditch my stockers for some good
> >quality units. What can you tell me as far as removeal
> >tips and replacement?
> >Thanks.
> >-Pete
> >Tampa, Fl
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
|