simple diagnois
your water pump is right above a sensor called the CPS .. or crank postion
sensor.
The weep hole of the water pump is directly above this sensor ... and when
the water pump starts to fail ... it will weep coolant out of the hole
directly on the dps sensor ...
After a while the sensor gets to hot and fails ... the EEC senses the
failure and shuts down the motor immediatly.
After the CPS sensor cools down .. you than can restart the motor.
You need a new water pump and sensor .... i also recommend replacing the
front main seal when down there and ONLY have someone who know there shit
about SHO's
dond
Sr 72 race preped 89 SHO
-3.2 ATX block
-FPS hi-flow heads w/ over sized valves
-.40 cams
-SHONUT adjustable timing sprockets
-Ported intake & runners
-Ported and extrude honed exhaust manifolds
-Hi-flow catless Y pipe
-Hi-flow exhaust
-BBB
-SHO SHOP T.B.
-SHONUT phenolic spacers
-Quaife
-CAI
-UDP
****
-17x7.5 Cobra R rims w/ Toyo Proxies Ra auto cross tires
-Complete sunpro gauges water temp / oil pressure
****
-Tokico shocks/Eibach springs
-Polyurethane at all corners
-Solid-sub frame bushings
-Frame stiffners
-full roll cage/6pt harness
-Adjustable rear control arms
-Battery located in trunk for better weight distrubution
****
-13" Cobra rotors and Calipers
-Steel braided lines
-race seat
-est 2850 pds :)
can u say "fast" ??
>From: "Jeremy" <jhallam@locl.net>
>To: <shotimes@autox.team.net>
>Subject: [Shotimes] Dies at idle when hot Help.
>Date: Sat, 15 Jul 2006 15:01:51 -0400
>
>Hello,
> I've been lurking for about a year..this is my first post. The
>problem
>that I am having is that my sho ('94 MTX) keep stalling on hot days after a
>driving period of about 1 hour or so. It seems to run fine, then if I let
>it
>sit an idle for about 1-3 minutes it stalls (almost like it is out of gas).
> I
>just did my 60K a couple of months ago, so I don't think it is the CPS. I
>also just cleaned the IAB with no luck. I pulled the codes and got these:
>511-no power to PCM pin 1 or bad PCM
>542- Fuel pump open/bad ground or always on
>411- Idle speed system not controlling idle properly
>225- Knock sensor not tested
>
>From these I am thinking that it probably has something to do with my fuel
>pump. Either it is bad, or not grounded. Am I on the right track, or way
>off?
>
>Jeremy
>'94 MTX y-pipe, LPM, K&N
>_______________________________________________
>Shotimes mailing list
>Shotimes@autox.team.net
>http://www.team.net/mailman/listinfo/shotimes
_________________________________________________________________
Is your PC infected? Get a FREE online computer virus scan from McAfee.
Security. http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
|