If you've followed the thread, I was asking questions about this since last
week, and in my post prior to the one you responded to, I explained why I did
not want to use the o-rings.
Thanks,
David
-----Original Message-----
>From: clubairth@bellsouth.net
>Sent: Jun 26, 2006 7:18 PM
>To: FlamingTaco <flamingtaco@earthlink.net>, shotimes@autox.team.net
>Subject: Re: [Shotimes] Valve cover bolt washers
>
>This has already been done. All you need to do is add a O-ring under the
>head of the bolt in addition to the factory seals. Search the forum. You can
>get them at Lowe's. You need a 16mm OD X 11mm ID O-ring. Very common. Every
>valvel cover I take off gets the O-ring trick!!
>.
>.
>.
>
>
>
>> While were on the subject, how many would be interested in washers to seal
>> the valve cover bolts? I'm thinking $10/set would do well to cover my
>> costs. This would be for the six center bolts only, and they would be used
>> in conjunction with the original seals.
>>
>> David
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
|