-------------- Original message ----------------------
From: "van Oss" <vanOss@centurytel.net>
> I'm replacing the rack on our '83 Mustang. Forgot to note which hose went
> into each port on the rack. Is there any special way of identifying which
> hole in the rack is for the pressure line, and which is the return line?
Offhand, I'd suspect the fitting sizes are different, to prevent assembly line
confusion. I had the rack replaced on Slorider, but it was done at a Goodyear
store.
Back in 2000 when the Wilwood brakes first went on Lowrider, I discovered (the
hard way) that the line fittings are different on left vs. right sides of the
car. If I had been aware that they were, it would have been a snap...as it
was, I tried to convert the left side fittings to right side types, thinking
the difference was the Wilwood parts.
Duhhhh!! ;-)
George
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
|