Here are the measurements: There are 5 holes for the spoiler's mounting studs
and 1 hole for the wires. The 5 mounting holes are 3/8" diameter and the hole
for the wires is 3/4" diameter. The forward holes on each end (toward the
front of the car) are 5 7/8" from the left and right edges of the lid,
respectively. Measure with the tape perpendicular to the edge of the decklid
and to the centerline of the holes. The 2 holes behind those, toward the rear
of the car, are 5 3/4" from the left and right edges of the lid. The distance
between the centerlines of each pair of holes is 1 25/32". The rearward holes
are "about" 1 13/16" from the rear edge of the lid (measure through the
centerlines of the pair of holes). I say "about" because the rear edge is a
radiused edge and is therefore a bit subjective. I didn't make any effort to
hold the tape against the lid down to the edge, I just held the tape down at
the hole and looked down on it as it went off the rear of the lid.!
You may be up to 1/16" off either way depending on whether you see it the
same way as I or not. Probably not enough to make a big difference. The
center hole is actually on the centerline of the lid. Use whatever method you
wish to find the centerline. The center hole is "about" 2 7/32" from the rear
edge of the lid. That leaves the hole for the wires. This hole is 3 1/16"
from the rear edge of the lid and 7" to the right (passenger side) of the
centerline of the lid. I don't know if a standard non-spoiler lid will have
the access holes on the underside for the nuts and the wiring so you may need
to make those too. I hope this all makes sense. If not, let me know.
Frank Whittle
'95 ATX
-----Original Message-----
>Date: Sat, 13 May 2006 13:24:45 -0400
>From: Jon Heese <shotimes@jonheese.com>
>To: shotimes <shotimes@autox.team.net>
>Subject: [Shotimes] Spoiler mount hole locations
>
>I'm in the process of adding a spoiler to a '92 trunklid, and instead of
>guessing and screwing it up (BTDT), I'm curious if anyone has measured
>and documented the location of the holes in reference to the edges of
>the trunklid...
>
>Or, if anybody feels like taking theirs off and measuring the hole
>locations to help out a fellow SHOwner, please let me know. =)
>
>Regards,
>Jon Heese
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
|