Better to err on the long side. That can be fixed (just like you need to do
with an old, stretched cable) by putting spacers between the pedal and the
cable end at the pedal. I used very small snap rings.
Ron Porter
-----Original Message-----
From: shotimes-admin@autox.team.net [mailto:shotimes-admin@autox.team.net]
On Behalf Of Ron Childs
Sent: Wednesday, May 03, 2006 1:45 AM
To: Shotimes
Subject: [Shotimes] Re: Adjusting / Replacing Throttle Cable
New throttle cables are scarce to non-existant (AFAIK). An alternative that
some
have used is to replace the inner cable in the existing cable housing. The
length of
the inner cable is critical (too short and it does not close all of the way,
too
long and you don't get WOT). A bicycle shop could probably supply an
appropriate
inner cable and ends. There may even be cable ends that can adjust length
with a set
screw.
-Ron
--- Chris Riedl <zap@columbus.rr.com> wrote:
> The '94 has a bad problem with its throttle cable, and I was curious
> where replacements can be found, and how one should go about greasing
> or changing the cable. The car jerks during acceleration due to the
> cable sticking. The pedal is also very heavy. I do suspect this is
> related to the cable and not the throttle spring, but has anyone ever
> heard of this before? I have greased the spring area numerous times
> with no improvement.
>
> The clutch cable on this car isn't so great either. Any suggestion
> there on a replacement?
>
> Thanks,
> -Chris
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
|