On Tue, Apr 13, 2021 at 6:39 PM Jack Brooks <JIBrooks@live.com> wrote:
>
> I am building a Sprinter van into an RV and have a question about the 120v
> breaker box (SquareD QO24L70RBCP). It is a 2-Space, 4-Circuit load center.
> My concern is that while the Neutral bar has four positions on a common bar,
> the two breaker connections are independent, without a common bar between the
> two. This surprised the heck out of me. My inverter (Victron 24/70/3000)
> has a single AC output with a â??cage clampâ?? terminal, not a screw down or
> stud terminal which would be easy. I can run a 6 or 8 AWG from the inverter
> to the Breaker box, but it needs to go to the two separate screw down
> terminals. Physically, I believe I can run an 8 AWG wire into one breaker,
> and then back out to the other breaker, but Iâ??m concerned about whether
> this is a code violation.
>
Ccan you post a picture of the inside of the box? I'd like to see the
bus baring.
--
David Scheidt
dmscheidt@gmail.com
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/shop-talk/mharc@autox.team.net
|