I would clean them out. It may not be required but now would be the best
& (only?) opportunity.
Alternatively, suggest the use of DOT 4. It is 'regular' brake fluid
(even though the label on the can will likely say "synthetic") with a
higher boiling point than DOT 3. And it'd be totally compatible with DOT 3.
DOT 5 (true silicone) has two advantages. 1) it won't eat at paint if
spilled/leaked and B) it doesn't absorb H2O. However it is more
expensive and, despite not absorbing water it should still be flushed
every few years. And if it is spilled/leaked will make repainting
problematic. (I've heard some painters won't touch a car that has been
'contaminated' with silicone). Since DOT 4 is not expensive, regular
flushing every few years is not so dear. And DOT 4 is readily available
should one need a supply while away from home. May not be true with DOT 5.
Eric Russell
Mebane, NC
On 5/16/2020 10:06 AM, Robert Nogueirao via Shop-talk wrote:
> Iâ??m helping a friend rebuild her brake system. All new lines and hoses.
> Iâ??ve rebuilt the calipers, brake cylinders and master cylinder and they are
> ready to install.
> Hereâ??s the problem:
> In rebuilding the cylinders I coated the bores lightly with red brake grease
> and DOT 3
> Fluid. Now she tells me she may want to go with Silicone fluid. Does that
> mean I need to disassemble and wash out all the cylinders and calipers?
> Thanks for any answers.
>
> Bob Nogueira
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/shop-talk/mharc@autox.team.net
|