Randall, you mentioned Loctite "circular parts mount". I don't see a loctite
product that seems to match. Recall the product name?
SKF recommends a "light layer of a non-hardening sealant". Are they talking
about JB Weld or other?
http://www.skf.com/binary/12-128020/11337_2-EN-SKF-Speedi-Sleeve.pdf - page 7
Thanks!
> Date: Thu, 28 Aug 2014 21:54:56 +0000
> From: tr3driver@ca.rr.com
> To: pj_mcgarvey@hotmail.com; shop-talk@autox.team.net
> Subject: Re: [Shop-talk] Cleaning up machined surface for oil seal
>
>
> > So either the new seal is just failing (it was after a track day), or
whatever
> > I did to clean up the surface made it worse, or just Murphy's dumb luck
and
> > it's leaking more now than before.
>
> Have you considered a Speedi-sleeve? You may have to look it up by size if
they don't have that particular application listed. I've had good luck using
a sleeve that was listed for a shaft some .010" larger than the one I had;
used some Loctite "circular parts mount" under it and it sealed fine.
>
> Something else to look at is how snugly the shaft fits into the bore that
supports it. On my Chevy, that bore was plain cast iron, and it wore
oversize, allowing the equivalent piece (the Chevy didn't use a flange, just a
CV joint) to wobble around.
>
> Randall
_______________________________________________
Shop-talk@autox.team.net
Archive: http://www.team.net/archive
|