Use a two part epoxy mix, dab it on wet-or-dry sandpaper and scrub a bright
spot on both surfaces; that gets the adhesive in contact with base metal
instead of oxides, add more mix and clap it in place . . it's going to
stay!
On Sun, Jul 20, 2014 at 7:08 PM, steve hochschild <shochschild@att.net>
wrote:
> JB Weld, no??
>
>
>
> On 7/20/2014 6:51 PM, Robert nogueira wrote:
>
>> I need to bond a one or two square inch piece of sheet aluminum to a
>> aluminum hood. The only purpose is stiffen a corner. I don't want to weld
>> it in place and have to deal with the hood warping.
>> What would be the best adhesive which will stand up to under hood heat.
>> Thanks for any suggestions
>>
>> Bob
>> _______________________________________________
>>
>> Shop-talk@autox.team.net
>> Donate: http://www.team.net/donate.html
>> Suggested annual donation $12.96
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage: http://autox.team.net/mailman/
>> options/shop-talk/shochschild@att.net
>>
> _______________________________________________
>
> Shop-talk@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/
> options/shop-talk/eltonclark@gmail.com
_______________________________________________
Shop-talk@autox.team.net
Archive: http://www.team.net/archive
|