On 23/10/2013, John Niolon <jniolon@att.net> wrote:
> I know there are some hams or experienced RF people on here so here's the
> question for them. I'm getting my old ham gear (only VHF and UHF) and
> getting
> some emergency communication ability back. I've had several rolls of RG-8
> stored in the loft of the garage for years.
>
> Wondering if it's deteriorated or degraded. I hooked up a test as follows
> xmitter to SWR bridge to coax test piece to dummy load ... saw full xmitter
> power on bridge (of course) and zero reflected
good sign
>
> Then xmitter to coax test piece to SWR bridge to dummy load and saw the
> same
> thing... reflected power was slight tick on the meter...a needle width..
need a better load possibly
>
> I see no continuity between shield and center conductor.
>
> Is there any other test I can do to this coax to assure I'm getting good
> thru
> put of RF ??
Measure power in and at the output end, what is the loss per length
does it match the spec for the cable at that frequency.
You only get reflected power if there are discontinueties.
If you have a really fast pulse generator, eg can produce a 1ns pulse
and a very fast scope then you can make a simple TDR (time domain
reflectometer) to look at reflections v time (distance is about 1ns
per ft) and whether any problem is above or below the impedance of the
cable.
Dave Caroline
>
> thanks
> John
>
>
>
> Many people are alive only because it's illegal to shoot them.
> _______________________________________________
>
> Shop-talk@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/shop-talk/dave.thearchivist@gmail.com
_______________________________________________
Shop-talk@autox.team.net
Archive: http://www.team.net/archive
|