> Check e bay for a machinist's tachometer. It is a little
> device that looks
> like a large key.
Thanks, Gerald. I am familiar with those, but using one is somewhat
problematic for me as I don't carry a watch (nor a wall clock in the shop
area). It also makes me nervous to have my hand near a spinning shaft while
I have to look away at something else. And I like the idea of being able to
measure surface speed directly, rather than having to do the computation.
Instead, I picked up one of the digital contact types at HF this morning.
In fact, I just came in from measuring all 16 lathe speeds (but haven't
tried to check the numbers for consistency yet). It seems to work well
enough. The readings are not rock-solid, but I think that is probably
because the lathe and it's single phase induction motor don't actually hold
a constant speed very well. The reading got more stable when I laid my hand
on the chuck (to provide a bit of load) and the worst case waver was less
than 1% of the reading.
-- Randall
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|