If you plan on doing any car painting with the air system, I would
recommend copper for it's ability to pull the heat and moisture out of
the air. I don't know if this hose is dramatically different than using
plastic piping, but I've heard of catastrophic failures where shards
were thrown into the work area. Just my 2 cents John Mitchell
On 8/4/2011 2:34 PM, Mark Andy wrote:
> Howdy,
>
> I know absolutely nothing about it, but it seems to be rated at 175psi
> _at 70 deg_ with only 140 psi at 140 deg. Presumably there's enough
> safety factor built in, but in my shop that stuff would see 175psi at
> as much as 95 deg if it gets really hot out / due to heat from the
> compressed air.
>
> Still, its attractive to me from an ease of assembly / modification
> standpoint. Copper is what I was going to use when I finally upgraded
> from my redneck "manifold and a lot of rubber air lines" system I have
> today. :-)
>
> Mark
>
> On Wed, 3 Aug 2011, David Hillman wrote:
>
>> Unbelievably to me, I searched the shop-talk archives, and found
>> not one mention RapidAir products ( ie RapidAir, Duratec, Maxline ).
>>
>> http://www.rapidairproducts.com/index.asp
>>
>> I refuse to believe that I've found something no here knew about,
>> so... comments? Experience? I'm considering installing the Maxline
>> (3/4") system, because the original RapidAir is only 1/2" and
>> apparently rated for 150psi. I may or may not buy the 175 psi
>> compressor I'm looking at, but it seems silly to save a few bucks here.
>>
>> Thanks.
>>
>> --
>> David Hillman
>> _______________________________________________
>>
>> Shop-talk at autox.team.net
>> Donate: http://www.team.net/donate.html
>> Suggested annual donation $12.96
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/shop-talk/marka at maracing.com
> _______________________________________________
>
> Shop-talk at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/shop-talk/jmitch at snet.net
|