The issue that I see is that with a vacuum you would only be able to create
... at best ... 14.7 psi at the joint. This might not be enough to push ...
or suck depending on how you want to look at it ... the thick liquid into
the leaking joint.
You mentioned that there are only minor leaks with over 100 psi in the
system. Removing all of the air from the system leaves you with only regular
air pressure on the outside of the joint and I suspect ... but can not prove
... that will not be enough to accomplish your goal.
I would think a very thin liquid would be a better choice to get into the
joint but a material that meets that criteria may not meet any of the other
criteria for sealing the system over time, vibration, etc.
Arvid
-----Original Message-----
From: eric@megageek.com
Sent: Wednesday, June 01, 2011 5:24 AM
To: shop-talk@Autox.Team.Net
Subject: Re: [Shop-talk] The air saga continues...
OK, here is a new idea I have for dealing with the leaks...
I found an epoxy that is like a thick liquid. I was thinking to put a
vacuum in the air lines (not sure of the best way to do that) then pour
the epoxy on the joints. This should draw the epoxy into the leaking
joints and form a better seal.
Anyone have any ideas about that? What's the best way to get a small
vacuum on an air line set up?
Moose
"Be as beneficent as the sun or the sea, but if your rights as a rational
being are trenched on, die on the first inch of your territory." Ralph
Waldo Emerson
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|