Now you're onto something-
You don't even need to buy any specialty items, just buy 2 short pieces of
steel tube, sized so that one will slide within the other one.
Weld the bigger piece to the side of the table, weld a flat plate to the
smaller piece so it looks like a big flyswatter, slide one end into the tube
that is welded to the table, bolt the flat plate on the other end to the base
of the tire changer.
> As for how to attach it to the table... I probably wouldn't use a clamp.
> instead, I'd make up something like a hitch receiver that you'd see on a
> pickup. Perhaps even just use those parts (you can get the hitch tubes at
> HF or Northern or whatever), but you could also make your own easy enough.
> Slip the mount in, put in the pin, and go to town.
|