The MAAP gas torch is probably hot enough; I would preheat the manifold to
around 500 degrees F or so, then it should bond. (The 'soft' flame on a acet
torch is probably a little cooler, but likely it's suggested to prevent
oxidizing the aluminum.)
I have done aluminum brazing several times (once using propane on a very small
repair), although it's been 15 years? since I last did it. One time was using
some rods from my grandfather, and another time was something I picked up at
the local welding supply shop. All of the repairs I did held up well-one was
for a CV carb bracket/housing for a 83 honda prelude. I did paint all the
repairs since I was not sure if corrosion would compromise the repair.
Good luck! Scott R
PS: I think tapping the hole for a aluminum bolt, sizing it for length, and
beveling the underside of the bolt head (and a matching bezel in the hole),
gluing it in w/ jb weld, and grinding it flush would also work well.
---------- Original Message ----------
From: Jim Stone <jandkstone99@msn.com>
I need to fill in a 1/8" hole in an aluminum intake manifold prior to having
it powder coated.
<snip>
Right now, the hottest torch I have is an old MAAP Gas one that has served me
well with small projects for many years, mostly plumbing.
____________________________________________________________
Globe Life Insurance
$1* Buys $50,000 Life Insurance. Adults or Children. No Medical Exam.
http://thirdpartyoffers.netzero.net/TGL3241/4d3267aca1e5cbe962fst01duc
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|