I'm working on an aluminum bonnet. Someone in the past had drilled some 1/4
inch holes in the panel to help hold Bondo in place. Why I don't know
because the bondo is very thin.
The aluminum bonnet is .050 thick and I'd like to not have the holes. Can I
have the holes welded up if I find a good welder ? Will there be a lot of
distortion if I do have it welded? Or, should I perpetuate the stupidity
and just fill the holes again with bondo and attempt to make the under side
as pretty as possible?
Thanks for any suggestions
Bob
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|