How about spring loaded pins then. I'm thinking about the type that is
used to secure a trailer tongue jack either vertical or horizontal.
Or
these:http://www.tractorsupply.com/agriculture-farming-ranching/3-point-hitch-parts/lock-pins/lock-pin-sw-pack-1833537
Peace,
Pat
Thusly spake Steven Trovato, On 7/2/2010 8:40 PM:
> Yes, I think that's what I was considering. One of the other things
> I'm trying to do is eliminate as much of the rattling as possible. I
> think bolts on chains might go against that goal.
>
> At 09:19 PM 7/2/2010, Pat Horne wrote:
>> How about drilling holes in the angle at the back and using bolts to
>> lock the ramps in place. That way you can move the ramps in and out
>> as needed.
>>
>> To keep track of the bolts, weld a small chain to them and the other
>> end to the trailer or ramp.
>>
>> Peace,
>> Pat
>
>
>
--
Pat Horne, Owner, Horne Systems
(512) 797-7501 Voice 5026 FM 2001
Pat@HorneSystemsTx.com Lockhart, TX 78644-4443
www.hornesystemstx.com
-- We support Habitat for Humanity - a hand UP, not a hand OUT --
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|