I'm replacing the head bolts on my SBC with ARP studs.
With the cap screws I used ARP's sealant (the bolts holes
open into the water jacket). I'd like to Loctite the studs in place
but not sure which produce to use. On the mains I used #262 (red)
but #271 "locks and seals (Enco catalog page 917) so I'm thinking this
may be a better choice - the catalog continues "...bearing retaining nuts,
cylinder liner studs, door closer plugs, ..." Any recommendations?
Sure was easier when all they had was "Nutlock" and Studlock"!
Thanks,
chad
--
"Our peculiar security is in the possession of a written
Constitution. Let us not make it a blank paper by
construction."
-- Thomas Jefferson, letter to Wilson Nicholas, 1803
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|