> the control arm bore is mic'ing 1.250 +/- .002 the bushings are
> anywhere
> from 1.260 to 1.268.
That's WAY too big, John. Something is wrong, probably mis-made parts. If
there is no expansion element (like a slit somewhere), then an interference
fit should be only a few .001" per inch of diameter.
One solution might be to mount the bushings up on a bolt or something that
you can spin in a drill motor or press; then use a file to work the outer
diameter down a bit.
A better solution would be to return them to the vendor (if that's an
option).
-- Randall
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|