Hello,
In my house, a previous owner finished the basement, and the interior walls
were done with sheet metal studs (a stupid idea, in my opinion). On the
unfinished side of the walls there is a lot of loose NM wiring for the outlets
and light switches which is not properly attached to anything. So, what is the
official, correct way to attach wiring to metal studs? (Of course, if the
studs were wood, I would simply use staples.) For wire runs that have to pass
horizontally, I have already installed plastic grommets in the holes in the
studs, but what about the vertical runs?
Thanks,
Doug
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|