Bob,
I think you are describing a Cleco fastener/clamp.
A number of sheet metal tooling vendors, including Aircraft Spruce whom I
happen to like, carry them. Do these look like what you're picturing?
http://www.aircraftspruce.com/catalog/topages/clecosheetholder.php
-vin
On Jan 4, 2010, at 9:05 AM, <nogera2@att.net> <nogera2@att.net> wrote:
> There is a little device I've seem used in sheet metal work that holds a
> panel in place via the screw holes. It is used as a temporary fastener
while
> doing the fitting. You place it in the screw hole and it acts like a
> reusable pop rivet.
>
> Can anyone tell me the name of the device and where they might be
available?
>
>
>
> Thanks in advance
>
>
> Bob Nogueira
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as vlm@te-motorworks.com
>
> Shop-talk mailing list
>
> http://autox.team.net/mailman/listinfo/shop-talk
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|