I guess I should update my question here as well. I bought the conductive
paint that was recommended here. I got it from that wacky scienfic company
(I can't remember the name now.) It worked perfectly, and I still have
enough for a bunch more repairs.
Thanks again to everyone on this list. I can always count on your guys for
the tough anwers.
Moose
"Be as beneficent as the sun or the sea, but if your rights as a rational
being are trenched on, die on the first inch of your territory." Ralph
Waldo Emerson
-----shop-talk-bounces@autox.team.net wrote: -----
To: <shop-talk@autox.team.net>
From: "scottmryan" <scottmryan@netzero.net>
Sent by: shop-talk-bounces@autox.team.net
Date: 11/17/2009 10:10
Subject: Re: [Shop-talk] conductive rubber
The conductive rubber does wear away with time, depending on how it was
manufactured. (if you have cleaned the pcb/other surface w/ tarnex (for
metal) and then water, or alcohol if carbon based contacts, it's probably
the pad (ohmmeter should show no more than 100-200 ohms when the points are
laid across the pad within 1/16" or so of each other, if it's greater than
500ohms, the pad is worn out). I did superglue very thin foil onto a few
pads once, it's still working, but does bounce sometimes. (it's the mute
button mostly)
I have seen a compound, I believe MCM electronics sells it, that is
supposed
to work that you brush onto the contact pad. I also saw someone use silver
conductive paint on contact pads, but this was not working at all when it
came in (was used on a memorymoog, contact pads have not been avail for
those for around 15 years).
Scott R
----- Original Message -----
> eric@megageek.com wrote:
>> OK, so I have a remote control that gets used alot. The main buttons
>> aren't registering any more.
>>
>> Is there a way to "clean" or "resurface" the button's conductive rubber
>> back side?
> I clean remotes and other keypads with just a dry paper towel and a
little
> knuckle grease. Unless it was immersed in something sticky, this is
> enough. Also, I've found the contacts, not the pads, are what need
> cleaning; they oxidize. A paper towel is rough enough clean them. If its
> really bad, use a pencil eraser followed with the paper towel. Pencil
> erasers have some mind grid embedded in them. Electrical engineers use
an
> eraser to clean non-gold plated contacts, the eraser will completely
> remove the gold and even copper plating.
>> What would happen if I just put a piece of metal there?
>>
> Don't know, just guessing, but you might get bounces (multiple button
> hits).
>
> Peter Thomas
>> TIA!
>>
>> Moose
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|