Pat, I forgot about the fact that the water will since to the bottom.
Makes me feel a lot more comfortable about the water idea. I did get
a reply about pumping exhaust fumes from a vehicle into the tank while
performing the drilling. I like that idea because I wouldn't have to
worry about having to get the water out of the tank.
Thanks!
Brad
On Wed, Jun 3, 2009 at 2:20 PM, Pat Horne <pat@hornesystemstx.com> wrote:
> Be that as it may, adding even a gallon or so ow water will isolate the
area
> where you will be drilling from the fuel if you let it sit for a few hours
> before drilling to let the water sink to the bottom of the tank.
>
> Use a left hand drill bit so that the heat and vibration might help to
> loosen the plug as you drill.
>
> Good luck.
>
> Peace,
> Pat
>
> Thusly spake Brad Kahler, On 6/3/2009 12:49 PM:
>>
>> Here's the situation. We recently bought a Bobcat 610 skid steer. We
>> got it at a very good price because someone sabotaged it (not me!) by
>> pouring dirt down into the fuel tank. Hence the entire fuel system
>> was gummed up with mud when the owner tried starting it. The fuel
>> tank is built into the left side of the frame and has a 1/8" pipe plug
>> at the bottom for draining purposes. As expected from something this
>> old the plug is frozen in place and all efforts to get it to unscrew
>> have only resulted in the plug head to be pretty much non existent
>> now.
>>
>> I realize I can syphon the old gas out but that will leave all of the
>> mud and gunk in the bottom of the tank on the outside near one of the
>> axles. What I'm thinking about doing is grinding the plug head flush
>> with the frame and then drilling through it with a 1/8" bit. In order
>> to keep sparks to a minimum or non existent I'm considering filling
>> the tank with water prior to drilling the hole.
>>
>> Once the hole is drilled and the tank is empty I would proceed with
>> enlarging the hole until the drain plug has been successfully removed.
>> I could the proceed with a thorough flushing of the tank to get the
>> mud and gunk out. I'm sure getting the gas/water mix to drain through
>> the 1/8" hole won't be easy but I'm not sure what else to do.
>>
>> Does this sound like a workable solution?
>>
>> Thanks,
>>
>> Brad
>> _______________________________________________
>> Support Team.Net http://www.team.net/donate.html
>>
>> You are subscribed as pat@hornesystemstx.com
>>
>> Shop-talk mailing list
>>
>> http://autox.team.net/mailman/listinfo/shop-talk
>>
>> http://www.team.net/archive
>>
>>
>>
>
> --
> Pat Horne, Owner, Horne Systems (512) 797-7501 Voice 5026 FM
2001
> Pat@HorneSystemsTx.com Lockhart, TX 78644-4443
> www.hornesystemstx.com
> -- We support Habitat for Humanity - a hand UP, not a hand OUT --
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|