What about sweating some solder in there like you would a copper pipe
joint, heat it up just enough to ooze solder into the joint ?
mike
On Tue, 2009-05-19 at 17:18 -0500, Karl Vacek wrote:
> It's just back from Redi-Strip. Clean and ready to seal - though I'll shoot
> brake cleaner and then flow some metal prep down there a day before anyway.
>
> Thanks !
> Karl
>
>
> > Karl Vacek wrote:
> >> I worry about cyanoacrylates (crazy glue) as being too brittle - are some
> >> grades more flexible ?
> >
> > I'd tend to agree.
> >
> >> Someone on the MG T-Series list suggested green Loctite 290 - I think
> >> that's the one for already-assembled fasteners. Anyone ever use that as
> >> a sealant ??
> >
> > It sounds like the best alternative, but I'd doubt that anything's going
> > to work unless and until the area around the hole, the shank, and the head
> > are clean.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|