Chris,
I'm not sure what the code says about BX cable outside, but where we
live (rural Texas) you find it all the time. Just be sure that there is
a drip loop in the cable so if any water gets into the cable that it
doesn't use the BX as a path to put water into the breaker panel. I see
a lot of BX painted, which will seal it more than just leaving it raw.
As to whether you have a neutral bus or not, just look to see where the
white wire from the main panel ends up. If there are only 3 wires - 2
insulated and one bare in the sub-panel, then go back to the main panel
and move one of the insulated wires to the bar where all the white wires
are.
Peace,
Pat
Thusly spake Chris Kantarjiev, On 5/10/2009 5:02 PM:
> Pat (and Donald, who replied directly):
>
> Thanks - that's a great idea. I don't know why I didn't think of it.
> Indeed, the original wiring used Romex, so I have a white lead. I
> can either change out the double-pole at the breaker or just leave
> it as is with one pole disconnected...
>
> I'm not sure there's a neutral bus in the subpanel, but it doesn't matter;
> there's only one circuit there.
>
> So.. what about using BX under the eaves?
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as pat@hornesystemstx.com
>
> Shop-talk mailing list
>
> http://autox.team.net/mailman/listinfo/shop-talk
>
> http://www.team.net/archive
>
>
>
--
Pat Horne, Owner, Horne Systems
(512) 797-7501 Voice 5026 FM 2001
Pat@HorneSystemsTx.com Lockhart, TX 78644-4443
www.hornesystemstx.com
-- We support Habitat for Humanity - a hand UP, not a hand OUT --
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|