Thanks to everyone for their suggestions. I've contacted the
Technical
Support people at Loctite, they were very helpful. The best product
is a urethane based epoxy. Also, I took the advise to "stake" the
ends
of the brads to slightly mushroom the head to keep the push nut from
coming loose.
Steve Hammatt
Mount Vernon WA USA
----- Original Message -----
From: "Art Halfnights" <halfnights@shaw.ca>
To: <shop-talk@autox.team.net>
Sent: Wednesday, April 01, 2009 11:31 AM
Subject: Re: [Shop-talk] Shop-talk Digest, Vol 3, Issue 80
> Hi Steve epoxy or glue would do the trick. You are wanting it to
> go around
> the shaft and between the belt and nut face even a good glue, would
> work if
> you put the glue around the shaft at the belt face and then screwed
> the nut
> on ,then the addietion would be better, belt face to nut face. And
> not too
> messy ??? A leather crafting outlet , or shoe repair or Lapages
> webb site
> might be the place to get the best glue??/ Regards Art Halfnights
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as gsteve@hammatt.com
>
> Shop-talk mailing list
>
> http://autox.team.net/mailman/listinfo/shop-talk
>
> http://www.team.net/archive
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.0.238 / Virus Database: 270.11.35/2034 - Release Date:
04/01/09 06:06:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|