At 09:23 PM 1/18/2009, John Mitchell wrote:
>I have a pin hole drip in one of the solder joints in my half inch
hot water line.
>I shut off the hot water, opened some valves and drained the line
out through a
>spigot I have in the garage......
John,
I don't know why I didn't think of this before. There is a new push coupling
called "shark bite". As long as your leak isn't right at a bend you
can cut out
the piece of pipe with the leak, and install one of the shark bite
couplings at each
end and simply insert a piece of pipe into the gap. They are a bit expensive,
about $5 each. I installed them on my front and rear spickets when I had to
replace them. No soldering!!! Plus they can be undone with a special tool.
John
John T. Blair WA4OHZ email: jblair1948@cox.net
Va. Beach, Va
Phone: (757) 495-8229
48 TR1800 48 #4 Midget 65 Morgan 4/4 Series V (B1106)
75 Bricklin SV1 (#0887) 77 Spitfire 71 Saab Sonett III
65 Rambler Classic
Morgan: www.team.net/www/morgan
Bricklin: www.bricklin.org
If you can read this - Thank a teacher!
If you are reading it in English - Thank a Vet!!
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|