Hi all,
I have a set of 2x6 rafters (25) that I need to notch for some 2x2 purlins.
There are 6 purlins per rafter, so a lot of notching....
The only way I'm aware of to make these notches is to saw a number of closely
spaced slots, then knock out the "fingers", and use a chisel to clean up the
groove.
Is there a better way to do this, given the number of notches required? I have
just basic hand and power tools (circ saw, jigsaw, router); no table saw or
anything else like that. Any ideas appreciated!
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|