Thanks for the suggestions!
I'm stuck using round tubing only because the current mounting brackets that
the rack will attach to require 5/8" round tubing. Since the minimum purchase
was 12', I figure I might as well make the rest of the rack out of that size
tubing...
I was looking for something similar to the clamps, but those blocks are too
much $$$ for this project (the rack is to hold a bookbag onto a scooter). I'm
going to try simply tacking a small strip to the tubing such that it doesn't
roll. I'll then be able to make all the cuts relative to the plate.
The tubing is small enough that I should be able to get away with just using a
large drill bit and press to notch the tubing.
Thanks!
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|