"EZ-outs" are shit. Don't even bother.
They are hard all the way through and thus break very easily.
Then you have a hard chunk of steel in the middle of your bolt.
I use a dremel tool and a stone to grind a divot
in the center of the broken off bolt. If it's not too hard
you can use a punch. You want a good center in order to
center the drill.
Left hand drill bits are good but I've never gotten around
to buying any. Even regular right hand drilling can
sometimes loosen up a stuck bolt.
Eric
On Wed, May 21, 2008 at 03:53:59PM -0700, Mike Rambour wrote:
> Left handed drill bits ! They work wonders, more than half the time
> they grab the bolt and remove it and the few times they don't grab it,
> well you were going to have to use a ez-out anyway, so let the left
> handed drill bit make the hole.
>
> mike
>
> Traci Pearson wrote:
> > I've had my share of sheared bolts on 510s, and
> > in the past I always had someone else extract
> > them for me. But I want to learn to do it on myself.
> >
> > This is a short 10 mm bolt that I know I didn't
> > really torque down, but age and vibration and
> > heat... Anyway, how can I get ahold of and back
> > out the bolt part that's left inside? The bolt
> > sheared below the lip of the hole, so there's
> > nothing sticking out to grab on to.
> >
> > I figured I'd start with some Liquid Wrench, but
> > what's the best way to proceed from there? It's
> > in an awkward place; I don't know if I could get
> > a drill bit (or attachment) straight onto it. Maybe my Dremel?
> >
> > What about those kits such as a GrabIt?
> >
> > Any ideas/techniques/advice are greatly appreciated!
> > Thanks!
> >
> >
> > Traci Pearson
> > Pearson Technical Communication
> > Writing, Editing, Information Design Print and Online
> > pearsontechcomm@comcast.net
> > (303) 410-9101
> >
> > When something can be read without great effort,
> > great effort went into its writing.
> > ~ Enrique Jardiel Poncela
> > _______________________________________________
> > Support Team.Net http://www.team.net/donate.html
> >
> > You are subscribed as mikey@b2systems.com
> >
> > Shop-talk mailing list
> >
> > http://autox.team.net/mailman/listinfo/shop-talk
> >
> > http://www.team.net/archive
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as ericm@lne.com
>
> Shop-talk mailing list
>
> http://autox.team.net/mailman/listinfo/shop-talk
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|