At 04:32 PM 4/15/2008 -0700, Mike Rambour wrote:
> For me yes TIG is easier but it is easier for several reasons. First,
>I learned to weld with oxy/acet torch and TIG is similar so I am used to
>it. I went to MIG and failed miserably on sheet metal, could weld all
>day long on thick stuff but sheet metal kept blowing through....
Mike,
I went to the local community college and took a MIG class. I've had a
Lincoln SP100 MIG welder for years but wanted to get some help with t
echnique and see if I could learn some new tricks. However, the welders
we had in class where BIG Hobart units and we were using .043 wire. Mostly
we did large plate 1/16" and up. About the end of the class, we did some
sheet metal. I could NEVER do it, I kept blowing through. But at home I
don't have any problems. I think partially because I use a lot thinner
wire (.023) instead of the .043. The .023 won't sustain as much current,
consiquently less heat. Yes I can crank my welder up and sit in one spot
and blow holes in the sheet metal, but I can also weld it.
So my point here, is that you may have been using the wrong size wire in
the MIG for the size sheet metal you were trying to weld.
John
John T. Blair WA4OHZ email: jblair1948@cox.net
Va. Beach, Va
Phone: (757) 495-8229
48 TR1800 48 #4 Midget 65 Morgan 4/4 Series V (B1106)
75 Bricklin SV1 (#0887) 77 Spitfire 71 Saab Sonett III
65 Rambler Classic
Morgan: www.team.net/www/morgan
Bricklin: www.bricklin.org
If you can read this - Thank a teacher!
If you are reading it in English - Thank a Vet!!
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|