Went and did more Googling for you. Supposedly, the test was the load
needed to remove a dowel pin, put finger-tight in a cold-rolled
low-carbon-steel bar before corrosion.
----- Original Message -----
From: "David Scheidt" <dmscheidt@gmail.com>
To: "Nolan" <foxtrapper@aceweb.com>
Cc: "Shop Talk" <shop-talk@autox.team.net>
Sent: Thursday, December 13, 2007 8:22 AM
Subject: Re: [Shop-talk] Mega Penetrant - any good
> On Dec 13, 2007 7:30 AM, Nolan <foxtrapper@aceweb.com> wrote:
>> Interesting!
>>
>> Did some searching around, and found these supposedly as the results of
>> the
>> April 2007 Machinist's Workshop magazine comparison test.
>>
>
> Which, without knowing their methods, is just a chart of numbers.
> (Knowing what I do about Machinist's workshop, not knowing their
> methods is just as informative and meaningful as knowing them.)
> What are they supposed to mean?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|