Actually it's not an easy to find common fitting. Especially
since I'm now back home and in the shop and
confirmed that my soft copper tubing size is 5/16"
(as confirmed by my clamp vice portion of my flaring tool).
None of the manufacturer's websites that
I've found so far make a 5/16" version; 1/4" and 3/8" yes, but
no 5/16". They make SOME other fittings, including a
flare-to-flare swivel straight connection in 5/16", but not the
5/16" elbow. Since I'm committed by my existing tubing AND even
more so by the 5/16" fitting on the carb seat fitting that I'm
attempting to utilize, then apparently I'll have to mickey-mouse
all sorts of adapters to accomplish my task of eliminating a large
loop in the gravity-feed fuel line or possibly rotate the Carter
BB-1 carb 180 degrees!
Steve Hammatt
Mount Vernon WA USA
----- Original Message -----
From: "Karl Vacek" <kvacek@ameritech.net>
To: "Steve Hammatt Mount Vernon WA USA" <gsteve@hammatt.com>;
<shop-talk@autox.team.net>
Sent: Thursday, August 23, 2007 9:28 AM
Subject: Re: [Shop-talk] Brass fittings (hopefully solved)
|
|
| I bet you can find this at the nearest NAPA or plumbing supply right
now.
| Home Dipstick or Lowe's, etc. too. It's a common fitting.
|
| Karl
snip
_______________________________________________
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
|