At 17:26 03/07/2007, John Miller wrote:
>I'm finally working on putting together a 'dedicated' junkyard set -
>sockets, wrenches, etc - I figure I need both metric and inch for the
>'middle' stuff - basically 3/8-10mm up through 18mm (can usually
>interchange 13mm and 1/2, of course...) but from 11/32 down you can
>pretty much always find something inch that'll fit any metric hex, and
>from 19mm up there's a lot of 'close enough' crossover.
>
>Minimizing the number of little things to lose and big things to carry
>matters in this application.
I've had good results over the years with this set:
http://tinyurl.com/ytwq3f
Add a ratchet and a t-bar and you can tackle most things up to heavy
plant. This one's UK sourced but I'm sure there's a Murrican one, at
half the price...
Nick Brearley
_______________________________________________
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
|