The grinding wheel on my Grizzly bench grinder was in need of
replacement. It has a 1/2" arbor. At Sears I found an appropriate
wheel, but with a larger hole. It comes with three concentric
plastic pieces that adapt the hole to smaller sizes. So, I put this
all together and the wheel does not seem to be centered. There is
enough play in these adapter pieces that I can "adjust" the wheel
slightly before I tighten the nut. I can't get it centered well
enough like this, though. So, what's the deal here? Is this "one
size fits all" concept just a bad idea? I'm thinking I should just
go buy a wheel with a 1/2" hole. Is that the way to go, or is there
some kind of special trick to this? Thanks.
-Steve Trovato
strovato@optonline.net
_______________________________________________
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
|