Original Message:
-----------------
From: Gordie's Garage
> Eric, I'm curious as to what bit you used for your 2" hole? A 2" masonry
> bit seems awfully large.
Well, it was quite a few years ago. The hole was large enough to pass some
~2" iron pipe through. I was relocating the fill & vent pipes for a fuel
oil tank.
IIRC, it was some sort of carbide masonary type drill. Certainly no water
was used. It was loud & dusty. My knee hurt because I'd lean on the drill
with my knee. THAT I still recall...
Eric Russell
Mebane, NC (but the foundation I 'drilled' was in MA)
--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .
|