I had a Delta contractor's saw for about 15 years and it was fine. Last
year I upgraded to a Grizzly cabinet saw (Unisaw knock-off) and I am quite
happy with it.
http://www.grizzly.com/products/item.cfm?itemnumber=G1023S
In addition to the basic saw I got the extra wide ripping capacity (built
my own side table) and the sliding table for cross cuts. I also built a
big outfeed table in back which doubles as a plywood storage cabinet. The
sliding table is nice and very precise, but it takes up a lot of room and I
probably wouldn't get it again, since I recently got a new radial arm saw
that does 98% of my cross cutting. However, when I got the sliding table I
was without a RA saw and wasn't sure if I was going to get another one.
Dave C
At 08:53 PM 11/23/2004 -0500, Eric@megageek.com wrote:
>OK, I'm looking at a new table.
>
>I'm looking for brands, places to buy, and things to look for. Anyone
>have any ideas?
|