If you have a pinhole leak in an oil pan that has what looks to be surface rust,
you can be sure that the metal is already thin and more holes will show up
soon. Any welding will likely burn through the thin (now thinner) sheet metal
and make a bigger hole than you had from the start. I have little experience
with JB Weld. How likely is that to adhere to an oily surface?
Can you remove the pan without removing the engine?
Eric@megageek.com wrote:
> OK, I've got my "work" truck. It's pretty beat and I'm not interested in
> spending big bucks on it or lots of time on it.
>
> Last week, the rear leaf spring broke. This morning I bought a new one (I
> couldn't find a used one and dang are new ones expense!)
>
> Anyway, I noticed while working on the truck, that there is a small pin
> hole in the side of the oil pan. (note the oil pan has surface rust.)
>
> Now, in my "sandblast the soupcracker" mindset, I think that I could just
> quickly clean up the area with a wire wheel and using the wire feed
> welder, on low, just put a dab over the hole.
>
> I wanted to run this by the list first.
>
> Is it possible to set the oil on fire in the jeep? Is there a better way,
> (That doesn't involve removal of the oil pan?)
>
> Thanks in advance!
>
> Inch
|