I use a pressure regulator just outside of the tank for the entire system.
That way I can easily regulate the pressure for whatever tool I am using.
Gordie Bird
Hi Mike,
Do you use a pressure regulator to control pressure at the tool
independently from pressure in the tank. That is, you can run the tool
at 90 PSI and the tank at 175 PSI.
I have been told that such tool pressure regulators don't work well, so
you really can't run the tank at full pressure. You must set the tank
pressure equal to the required tool pressure.
Don Malling
Mike Rambour wrote:
>
> At 10:03 PM 1/12/2004, David Scheidt wrote:
>
>>> Ok folks, I have not picked up the one I was asking about YET. As I am
>>> comparing the ones out there It appears there is some overlap in
>>> specs between
>>> single stage and two stage. Because I don't know any better I'm
>>> thinking 2 is
>>> better than 1 right? What are the advantages/disadvantages between
>>> the two?
>>
>
> It used to be the big difference was air pressure, generally single
> stage was 125psi and two stage were 175psi. Lately however I have seen
> single stage with 150 and 160psi so that is no longer a rule.
>
> But the higher pressure is important because a 60gal or 80gal tank
> with 175psi of air is storing a huge amount more than 125psi, compressor
> works less with more air stored.
>
> mike
|