Hi,
First post to this list.
What I usually do for interior sheet metal around roll bars is cut them
carefully by hand with snips or use a combination of Greenlee knock-out
punches and snips. Nibblers don't make nice clean holes and you usually
can't get power shears into these tight cut-outs very well.
Hope this helps.
Joe Szwed
At 12:52 PM 11/25/2003 -0500, Mark Andy wrote:
>Howdy,
>
>I'm going to be needing to cut a bunch of sheet metal to piece in around
>rollcage tubes. There'll be a few of us working and I've only got one
>plasma cutter which is what I normally use for this kinda thing.
>
>What other good ways are there to cut sheet metal? I've seen nibbler type
>things, but never held one or used one. Do they work well? Do they make
>electric powered ones? (the plasma will be using the air...) How thick
>can they cut?
|