OK, now the difficult part......has anybody ever seen
a taper lock bushing with a multi-step pulley?
that's the combination that I'm looking for.
Thanks
Steve
----- Original Message -----
From: "Dave C" <cavanadd@kendra.com>
To: "Dick Atkinson" <dick@grinalot.freeuk.com>; <>
Sent: Friday, November 14, 2003 7:28 PM
Subject: Re: Pulley questions
>
> At 02:11 PM 11/14/2003 +0000, Dick Atkinson wrote:
> >When two Allen screws
> > > are tightened (the Allen screws are fitted half-way in the
> > > center section and half-way into the outer section) there
> > > is a very positive clamping affect around the center bore
> > > hole.
> > >
> >
> >Steve,
> >
> >In the UK they are known as taper lock bushings.
>
>
> That's what they are called in the US, too, at least, that's what I have
> always called them. I have never seen a taper lock pulley on a consumer
> product or light woodworking (or metal working) tool. I have always
> encountered them on industrial equipment, usually on larger shafts where a
> lot of torque is being transmitted. Very common on big fans and
> such. They are available through any industrial belt and drive supplier,
> but they're expensive.
>
> Dave C
snip
|