Wayne Farrington wrote:
>
> I am looking for a type of ball detent pin. Actually it is not a ball detent
> pin in the traditional sense. I know I've seen these in industry but can't
> figure out what they are called. It is a pin with a T handle and button just
> like a traditional ball detent pin. But instead of having a ball on the other
> end it has a lever that pivots from being in the same plane as the pin to
> being 90 deg. from it and locks in that position until the button is pushed.
> When the button is pushed the lever pivots back in line with the pin and you
> can pull the pin out of the hole.
>
What you're looking for are called "pip pins". Here's a decent link:
http://www.jergensinc.com/pins2.htm
(But, as you'll see, if you'd googled for "ball detent pin", you would
have found this, too!)
chris
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|