>I have been trying to clean my rums in a bead blast cabinet I made.
>Question is that all the fine dust/dirt that I am knocking off the rims
>keep clogging up the exhaust filter causing the visibility to go to zero
how are you exhausting the stuff out ? is it just a shop vac or are you
just hoping for it to exit the cabinet on its own ?
I got a small shop vac from kmart to exhaust my bead cabinet at first, it
was not good enough and would eventually cause my visibility to zero, I
finally broke down and purchased a full blown exhaust vac from TP Tools. I
built my cabinet with their plans.
A blast cabinet I don't think can work strictly on incoming air pressure
to exhaust the dust, I would have believed it could since I was pumping
large amounts of air into the cabinet and forcing positive pressure. But I
think it needs some kind of exhaust system, I only think so because of my
experience with too small a shop vac.
Mike
~~~~~ I'd rather be sailing and ~~~ .oooO Oooo. ~~~~~~~~~~~
Mike Rambour ( ) ( )
Bug Writer er...Programmer \ ) ( /
mikey@b2systems.com \_) (_/
**********************************************************************
If you want to learn more about the ULTIMATE BRITISH sports car,
then take a look at http://www.singercars.com/
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|