I'm now the proud owner of two wire welders... a small 100 amp 110v hobart
and a Millermatic 200. I plan on keeping both of them on the same roll
around cart with my plasma cutter and my stick machine. The back of this
cart has a bottle rack for the C25 mix I use for shielding gas.
Is there any reason that I couldn't tee off this line after the flowmeter
and feed both welders from the same bottle ?? I can't think of one... but
there are lots of things I don't know ... yet...
comments ???
thanks
john
I've never completely understood anything !!!
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|