Kai,
Have you tried a Torx bit to see if it will fit? Another very good
possibility is to grind the tip of a flat blade screwdriver to fit
inside of two opposing slots.
Dave Russell
Kai M. Radicke wrote:
>
> Well, I guess I should have clarified that, two of the screws on the dashpot
> are not removable using my snap ring pliers because they are located too
> closely to obstructions on the carb body.
>
> If I can find a pair of snap ring tips that are bent at 90 degrees tomorrow
> at Lowes, that might do it, but I'm not optimistic about that working.
>
> Kai
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|