On Thu, Jan 02, 2003 at 05:37:54PM -0500, Rush wrote:
>
>All the runs are straight with no complicated jogs or bends. Would replacing
>them
>with more insulated duct, or better yet galvanized steel duct, be within the
>realm of a do-it-yourselfer, assuming I could rent the necessary bending
>equipment? I probably couldn't do a worse job than what was done already.
ANy reason you can't run insulated flexible ducting?
jim
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|