In a message dated 11/8/02 11:51:07 AM Pacific Standard Time, jgates@tx3.com
writes:
> If you heat this area, the
> suggested perimeter insulation is a good idea.
>
- - - - - - - - - -
I am getting a lot of good info from you all...y'all...whatever.
Now, explain the perimeter insulation. I would like to have the floor ready
to pour when the truck gets there. 8' X 2' X 2" styrofoam was suggested, but
try to explain where it goes. Does it ring the perimeter, laying flat
underneath the edge of the concrete, touching the cinder block foundation,
then in 2 ft. all the way 'round? Wouldn't the weight of the concrete
compress it? Does the vapor barrier go on top of it?
TIA, once again,
Allen Hefner
Phila. Region SCCA Rally Steward
'77 MG Midget
'75 MG Midget (The Project)
'92 Mitsubishi Expo LRV Sport
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|